Features
Features
Top discharge allows for superior cooling of motor and provides a slim line design
304 stainless steel motor housing superior abrasion resistance will not wear out like aluminum motor housings when pumping sandy water
Three seal motor protection - motor is protected by double mechanical seals
Lower seal made of silicon carbide and upper seal is made of carbon/ceramic
An additional lip seal has been installed above the impeller, to help prevent abrasives such as dirt, silt or sand, from entering into the seal chamber
More motor protection - winding protection and NEMA class F motor insulation allows motor temperature to raise to 230 deg F, superior to pumps with class A and B insulation
Automatic switch turns pump motor off if temperature and/or amp draw raises too high
When the motor cools the switch will automatically reset and the pump will turn back on
Tough pump construction - hardened cast iron stands up to rough handling and pumping sandy water unlike pumps with soft resin impellers or plastic exterior components
Longer power cord - standard 50 ft power cord
